Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
55412C
1.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
55670
2.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55680A
3.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
55521C
4.REMOVE STEREO OPENING COVER (w/o Audio)
86120
5.REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)
6.REMOVE NAVIGATION RECEIVER (w/ Navigation System)
55411G
7.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL
55900
8.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
55012A
9.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
88625Q
10.REMOVE COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR
Detach the 2 claws and disconnect the cooler (room temperature sensor) thermistor from the instrument panel.
Pull out the cooler (room temperature sensor) thermistor and disconnect the connector and aspirator pipe to remove the cooler (room temperature sensor) thermistor.