Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
1.INSTALL AIR CONDITIONING PANEL ASSEMBLY
Attach the 2 claws to connect the No. 2 heater control cable sub-assembly to the air conditioning panel assembly.
Attach the 2 claws to connect the air mix damper control cable sub-assembly to the air conditioning panel assembly.
Connect the connector.
Attach the 2 hooks and 2 claws to install the air conditioning panel assembly.
2.INSTALL NAVIGATION RECEIVER (w/ Navigation System)
86120
3.INSTALL RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)
55521C
4.INSTALL STEREO OPENING COVER (w/o Audio)
55680A
5.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
55670
6.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55412C
7.INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL