Home › Vehicle Interior › HEATING / AIR CONDITIONING › HEATER FUEL PUMP
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0050043 HEATER FUEL PUMP G

HEATING / AIR CONDITIONING  HEATER FUEL PUMP  INSPECTION  


PROCEDURE

Hide 87260 1.INSPECT HEATER PUMP ASSEMBLY

E176914
2.448,1.542 2,1.198 false 1.031,1.563 1.479,1.219 false 0.063,0.031 0.24,0.198 0.177,0.167 10 *a 2.469,1.49 2.667,1.656 0.198,0.167 10 B2 0.781,1.5 0.979,1.667 0.198,0.167 10 E2
*a Component without harness connected
(Heater Pump Assembly)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (B2) - 2 (E2) Always 9 to 12 Ω



b.

Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, and check the pressure of the hose by hand.

NOTICE:
·

This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.

·

Always switch the voltage on and off on the battery side, not the heater pump assembly side.

·

Keep the heater pump assembly as far away from the battery as possible.



OK:

Pressure is applied to the hose.


If the result is not as specified, replace the heater pump assembly.