Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050069 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 83950M 1.INSPECT TELLTALE LIGHT ASSEMBLY (HAZARD WARNING SWITCH)

a.
E269059
1.646,1.021 1.969,0.406 true 2.5,1.219 2.906,1.146 true 1.906,0.229 2.219,0.427 0.313,0.198 10 TB 0.104,0.094 0.417,0.292 0.313,0.198 10 *a 2.958,1.052 3.115,1.25 0.156,0.198 10 E
*a Component without harness connected
(Telltale Light Assembly (Hazard Warning Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
7 (TB) - 13 (E) Hazard warning signal switch off 10 kΩ or higher
Hazard warning signal switch on Below 1 Ω


If the result is not as specified, replace the telltale light assembly (hazard warning switch).