85035R
1.INSPECT REAR WASHER NOZZLE SUB-ASSEMBLY
With the ignition switch turned to ON check that the center stream of washer fluid sprays on the back door glass within the hatched area shown in the illustration.
Washer fluid hits the back door glass in the area shown in the illustration.
If the result is not as specified, adjust the rear washer nozzle sub-assembly.
| *1 | Glass Edge | *2 | Wiper Pattern |
| Area | Specified Condition | Area | Specified Condition |
|---|---|---|---|
| A | 37.5 mm (1.4764 in.) | B | 81.5 mm (3.2087 in.) |
| C | 138.6 mm (5.4567 in.) | D | 139.9 mm (5.5079 in.) |