Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM3090E _59 Vehicle Exterior _008795 WIPER / WASHER _0050096 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  INSTALLATION  


PROCEDURE

Hide 89944 1.INSTALL RAIN SENSOR TAPE

NOTICE:

The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.


a.

Clean the rain sensor sensing portion with a piece of cloth, etc.


b.
E179754
1.104,1.25 1.563,1.406 true 1.406,3.198 1.604,3.375 0.198,0.177 10 B 0.51,2.271 0.708,2.448 0.198,0.177 10 A 0.823,1.156 1.083,1.344 0.26,0.188 10 *1
*1 Rain Sensor Tape


Peel off the smaller release sheet, and then attach the rain sensor tape on the rain sensor sensing portion as shown in the illustration.

Standard:
Area Measurement
A 13.5 mm (0.532 in.)
B 7.5 mm (0.295 in.)


NOTICE:

Use your fingers to push out any air bubbles from under the tape.



Hide 89941 2.INSTALL RAIN SENSOR

a.

Clean the windshield glass with a piece of cloth, etc.

NOTICE:
·

Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

·

If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.




b.

When installing a new rain sensor or replacing the rain sensor tape:

i.

Peel off the release sheet.

HINT:

Do not touch the silicon coated surfaces.



ii.
E182986
0.979,1.521 1.125,1.521 1.125,1.521 1.271,1.604 false 1.052,0.656 1.458,1.104 true 0.875,0.677 1.094,0.667 1.094,0.667 1.865,0.792 true 0.74,1.438 1.01,1.635 0.271,0.198 10 *1 2.354,1.688 2.656,1.917 0.302,0.229 10 (1) 1.281,1.885 1.646,2.094 0.365,0.208 10 (2) 0.594,0.573 0.906,0.771 0.313,0.198 10 *2
*1 Stopper
*2 Guide


Attach the 2 guides, and then carefully install the rain sensor to the glass surface so that air bubbles do not form between the contact surfaces.

NOTICE:

Do not touch the silicon coated or glass surfaces.



iii.

Push in the stopper.


iv.

Connect the connector.



Hide 89943 3.INSTALL RAIN SENSOR COVER

E270249

a.

Attach the 2 claws to install the rain sensor cover.


b.

Slide the cover as shown in the illustration.