Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM3090E _59 Vehicle Exterior _008795 WIPER / WASHER _0050096 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  REMOVAL  


PROCEDURE

Hide 89943 1.REMOVE RAIN SENSOR COVER

E270248

a.

Slide the cover as shown in the illustration.


b.
E270247

Detach the 2 claws and remove the rain sensor cover.


Hide 89941 2.REMOVE RAIN SENSOR

a.
E270250

Disconnect the connector.


b.
E179753
0.917,1.479 1.073,1.479 1.073,1.479 1.292,1.594 false 0.635,1.406 0.938,1.615 0.302,0.208 10 *1 2.302,1.667 2.646,1.885 0.344,0.219 10 (2) 1.115,1.927 1.469,2.115 0.354,0.188 10 (1)
*1 Stopper


Release the stopper by pulling it down.


c.

Remove the rain sensor as shown in the illustration.


Hide 56111 3.CLEAN WINDSHIELD GLASS

NOTICE:
·

The rain sensor tape can be reused; however, replace it with a new piece of tape if it is dirty or damaged.

·

Check that the rain sensor tape does not remain on the windshield glass. If it does, remove it before installing the rain sensor.