Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER CONTROL RELAY
RM3090E _59 Vehicle Exterior _008795 WIPER / WASHER _0050097 HEADLIGHT CLEANER CONTROL RELAY G

WIPER / WASHER  HEADLIGHT CLEANER CONTROL RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85942 1.INSPECT HEADLIGHT CLEANER CONTROL RELAY

a.
E186708
2,0.833 2.417,0.417 false 1.26,0.844 0.833,0.5 false 2.01,1.427 2.417,1.833 false 1.667,1.5 1.667,1.833 false 1.25,1.417 0.917,1.833 false 2.469,0.333 3.083,0.531 0.615,0.198 10 HOLD 0.844,1.844 1.458,2.042 0.615,0.198 10 PB 2.469,1.792 3.083,1.99 0.615,0.198 10 E 1.49,1.865 2.104,2.063 0.615,0.198 10 FRWA 0.667,0.385 1.281,0.583 0.615,0.198 10 IG 0.052,0.052 0.365,0.208 0.313,0.156 10 *a
*a Component without harness connected
(Headlight Cleaner Control Relay)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (PB) - 4 (E) Battery voltage not applied 10 kΩ or higher
Battery positive (+) → Terminal 3 (IG)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)
Battery positive (+) → Terminal 3 (IG)
Battery negative (-) → Terminal 4 (E)
Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount
Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 1 (HDLO)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)


If the result is not as specified, replace the headlight cleaner control relay.