Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR
RM3090E _59 Vehicle Exterior _008795 WIPER / WASHER _0050099 FRONT WIPER MOTOR G

WIPER / WASHER  FRONT WIPER MOTOR  INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Make sure that fingers or articles of clothing do not get caught in moving parts when performing this test.


PROCEDURE

Hide 85110 1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)

E132856
1.083,1.833 1.49,1.417 false 1.917,1.427 2.344,1.833 false 1.333,1 0.917,0.75 false 0.083,0.063 0.396,0.26 0.313,0.198 10 *a 0.979,1.844 1.292,2.042 0.313,0.198 10 +1 2.354,1.844 2.51,2.042 0.156,0.198 10 E 0.729,0.646 0.969,0.833 0.24,0.188 10 +2
*a Component without harness connected (Windshield Wiper Motor Assembly)


a.

Check the LO operation.

i.

Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 5 (+1)
Battery negative (-) → Terminal 4 (E)
Motor operates at low speed




b.

Check the HI operation.

i.

Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (+2)
Battery negative (-) → Terminal 4 (E)
Motor operates at high speed


If the result is not as specified, replace the windshield wiper motor assembly.



Hide 85110 2.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)

a.
E132856
1.083,1.833 1.5,1.417 true 2.333,1.833 1.917,1.417 true 2.073,0.958 2.49,0.625 true 2.313,1.823 2.625,2.021 0.313,0.198 10 +2 2.531,0.521 2.844,0.719 0.313,0.198 10 +1 1.01,1.833 1.323,2.031 0.313,0.198 10 E
*a Component without harness connected (Windshield Wiper Motor Assembly)


Check the LO operation.

i.

Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1 (+1)
Battery negative (-) → Terminal 5 (E)
Motor operates at low speed




b.

Check the HI operation.

i.

Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 4 (+2)
Battery negative (-) → Terminal 5 (E)
Motor operates at high speed


If the result is not as specified, replace the windshield wiper motor assembly.