Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR
RM3090E _59 Vehicle Exterior _008795 WIPER / WASHER _0050099 FRONT WIPER MOTOR A

WIPER / WASHER  FRONT WIPER MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.


·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 85192 1.REMOVE WINDSHIELD WIPER ARM COVER

a.
E268322
1.365,1.802 0.75,1.365 true 0.552,1.24 0.865,1.438 0.313,0.198 10 *1
*1 Protective Tape


Using a screwdriver, detach the 3 claws and remove the windshield wiper arm cover.

HINT:
·

Tape the screwdriver tip before use.

·

Use the same procedure for both windshield wiper arm covers.




Hide 2.REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH

a.
E268323

Remove the nut and the front wiper arm and blade assembly LH.


Hide 3.REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH

a.
E268324

Remove the nut and the front wiper arm and blade assembly RH.


Hide 53867H 4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

a.
E268325

Detach the 2 claws and remove the double-sided tape.


b.

Detach the 2 guides, and remove the front fender to cowl side seal LH.


Hide 53866J 5.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:

Use the same procedure described for the LH side.


Hide 55781E 6.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

a.

Remove the 2 clips.


b.

Detach the 5 claws and 2 guides as shown in the illustration.

E268326


c.

Detach the 9 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.

E268327


Hide 7.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

NOTICE:

Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.


a.
E268328
2.229,0.271 1.948,0.438 true 2.25,0.177 2.563,0.375 0.313,0.198 10 *1
*1 Motor Grommet


Remove the 2 bolts and disconnect the connector.


b.

Detach the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.


c.
E268329

Disconnect the connector and detach the clamp.


Hide 85110 8.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

a.
E268330
1.229,1.385 1.25,0.5 true 1.156,0.323 1.417,0.49 0.26,0.167 11 *1
*1 Protective Tape


Using a screwdriver, separate the No. 1 rod from the wiper motor pivot as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



b.
E268331

Remove the 3 bolts.


c.
E268332
0.656,1.198 0.813,1.396 0.156,0.198 10 1 1,0.531 1.156,0.729 0.156,0.198 10 2

Rotate the windshield wiper motor assembly in the direction of the arrows as shown in the illustration and remove the windshield wiper motor assembly from the link.