67939B
1.REMOVE BACK DOOR CENTER GARNISH
84280D
2.REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)
84270G
3.REMOVE POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door)
Use the same procedure described for the LH side.
64886B
4.REMOVE BACK DOOR GLASS CHANNEL LH
| *1 | Double-sided Tape |
Remove the clip.
Detach the double-sided tape to remove the back door glass channel LH.
64885C
5.REMOVE BACK DOOR GLASS CHANNEL RH
Use the same procedure described for the LH side.
76871
6.REMOVE REAR SPOILER
When removing the rear spoiler, heat the vehicle body and rear spoiler using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Rear Spoiler | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or rear spoiler excessively.
|
Connector |
|
Clamp |
Disconnect the connector and detach the clamp.
Remove the 4 nuts.
Using a heat light, heat the vehicle body and rear spoiler.
| *1 | Protective Tape |
| *2 | Wooden Block |
| *3 | Double-sided Tape |
Put protective tape around the rear spoiler.
Insert piano wire between the vehicle body and rear spoiler.
Tie objects that can serve as handles (for example, wooden blocks) to the piano wire ends.
Pull the piano wire and scrape off the double-sided tape.
Be careful not to damage the vehicle body.
Detach the 5 clips and remove the rear spoiler.