Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR OUTSIDE GARNISH(for Upper Side) › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008798 EXTERIOR PANELS / TRIM _0050111 BACK DOOR OUTSIDE GARNISH(for Upper Side) A

EXTERIOR PANELS / TRIM  BACK DOOR OUTSIDE GARNISH(for Upper Side)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS


PROCEDURE

Hide 84840G 1.INSTALL BACK DOOR OPENER SWITCH ASSEMBLY

Hide 76801 2.INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

a.

Attach the 4 clips to install the back door outside garnish sub-assembly.


b.

Connect the connector.


c.

Install the 4 nuts.


Hide 3.INSTALL REAR LIGHT ASSEMBLY LH

Hide 4.INSTALL REAR LIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 84280D 5.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)

Hide 84270G 6.INSTALL POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door)

HINT:

Use the same procedure described for the LH side.


Hide 67750 7.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 67938A 8.INSTALL BACK DOOR SIDE GARNISH LH

Hide 67937B 9.INSTALL BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure described for the LH side.


Hide 67939B 10.INSTALL BACK DOOR CENTER GARNISH