When the combination switch assembly (ECO mode switch) is turned on, the air conditioning amplifier assembly receives an combination switch assembly (ECO mode switch) ON signal and controls the air conditioning to enhance fuel efficiency.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ECO Switch | Combination switch assembly (ECO mode switch) | OFF or ON | OFF: Combination switch assembly (ECO mode switch) not operated
ON: Combination switch assembly (ECO mode switch) operated |
- |
| Tester Display |
|---|
| ECO Switch |
Combination switch assembly (ECO mode switch) condition displayed on the GTS changes with the actual switch operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the combination switch assembly (ECO mode switch).
Click hereVehicle Interior>HEATING / AIR CONDITIONING>ECO SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (ECU) - 4 (MSW2) | Combination switch assembly (ECO mode switch) off (when switch is not pressed) | 10 kΩ or higher |
| 3 (ECU) - 4 (MSW2) | Combination switch assembly (ECO mode switch) on (when switch is pressed) | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G80 air conditioning amplifier assembly connector.
Disconnect the G60 combination switch assembly (ECO mode switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G80-18 (ECOS) - G60-3 (ECU) | Always | Below 1 Ω |
| G80-18 (ECOS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Combination Switch Assembly [ECO Mode Switch]) |
Disconnect the combination switch assembly (ECO mode switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G60-4 (MSW2) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG