Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY(for HID Headlight) › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050130 HEADLIGHT ASSEMBLY(for HID Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for HID Headlight)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 81610F 1.INSTALL CLEARANCE LIGHT BULB (w/o Daytime Running Light)

a.
E268984

Install the clearance light bulb to the clearance light socket.


b.
E268982

Turn the clearance light socket with the clearance light bulb in the direction indicated by the arrow to connect them as a unit.


Hide 81510C 2.INSTALL FRONT TURN SIGNAL LIGHT BULB

a.
E268980

Install the front turn signal light bulb to the front turn signal light socket.


Hide 81515B 3.INSTALL FRONT TURN SIGNAL LIGHT SOCKET

E268978

a.

Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow to install them as a unit.


Hide 81110D 4.INSTALL NO. 2 HEADLIGHT BULB

a.
E268976

Turn the No. 2 headlight bulb in the direction indicated by the arrow to install it.

NOTICE:

Do not touch the glass part of the bulb.



Hide 81110L 5.INSTALL DISCHARGE HEADLIGHT BULB

E268965N01
1.156,0.25 1.615,0.448 0.458,0.198 10 (1) 2.229,0.865 2.688,1.063 0.458,0.198 10 (2) 0.365,0.938 0.823,1.135 0.458,0.198 10 (2)

a.

Set the discharge headlight bulb to the headlight unit.


b.

Lock the set spring in the order shown in the illustration to install the discharge headlight bulb to the headlight unit.

NOTICE:

Do not touch the discharge headlight bulb glass.



Hide 81134 6.INSTALL HEADLIGHT GASKET

a.

Install a new headlight gasket to the headlight light control ECU sub-assembly.


Hide 81107 7.INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

a.
E268963

Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration to connect the headlight light control ECU sub-assembly socket.

NOTICE:
·

Check that the headlight gasket is installed on the headlight light control ECU sub-assembly.

·

Check that the headlight gasket is not damaged or contaminated with foreign matter. If there is any damage, replace the headlight gasket with a new one.

·

Do not pull the headlight light control ECU sub-assembly with the socket connected.




b.
E268961

Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow in the illustration to install the headlight light control ECU sub-assembly to the headlight unit.