SYSTEM DIAGRAM
Overall CAN Bus Diagram
Control system CAN is composed of 5 buses.
| No. | ECU/Sensor Name |
|---|---|
|
*1: for 4WD/AWD *2: w/ Stop and Start System *3: for Radio and Display Type *4: for Navigation Receiver Type *5: w/ Entry and Start System *6: w/ Blind Spot Monitor System *7: w/ Power Back Door System *8: for 2AD-FHV, 2AD-CCo and Automatic Transaxle *9: for 3ZR-FAE *10: for 3ZR-FAE, 1AD-FTV |
|
| 1 | ECM |
| 2 | Air conditioning amplifier assembly |
| 3 | Main body ECU (multiplex network body ECU) |
| 4 | Brake actuator assembly (skid control ECU) |
| 5 | Power steering ECU assembly |
| 6 | Spiral with sensor cable sub-assembly (steering angle sensor) |
| 7 | DLC3 |
| 8 | Airbag sensor assembly |
| 9 | 4WD ECU assembly*1 |
| 10 | Engine start and stop ECU*2 |
| 11 | ·
Radio and display receiver assembly*3 ·
Navigation ECU sub-assembly*4 |
| 12 | Certification ECU (smart key ECU assembly)*5 |
| 13 | Blind spot monitor sensor LH*6 |
| 14 | Combination meter assembly |
| 15 | Multiplex network door ECU*7 |
| 16 | No. 6 CAN junction connector |
| 17 | ·
Transmission control ECU assembly*8 ·
Continuously variable valve lift controller assembly*9 |
| 18 | Blind spot monitor sensor RH*1 |
| 19 | Battery current sensor assembly*10 |
The main body ECU (multiplex network body ECU) functions as a gateway between the V bus and sub bus 1.
Refer to the following bus wiring diagrams for details.
V Bus
The CAN communication system connects to other networks via ECUs that function as a gateway.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Sub Bus 1 (w/ Power Back Door System)
The CAN communication system connects to other networks via ECUs that function as a gateway.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Sub Bus 15
Sensor Bus (w/ Blind Spot Monitor System)
Local Bus (for 3ZR-FAE or 1AD-FTV)