Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050194 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89408C 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.

Check the rear height control sensor sub-assembly LH.

i.

Connect 3 dry batteries of 1.5 V in series.


ii.

Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 1 (SHG) and terminal 2 (SHRR).


iii.

Measure the voltage according to the value(s) in the table below.

NOTICE:
·

Do not apply a voltage of more than 6 V.

·

Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.



Standard Voltage:
Tester Connection Condition Specified Condition
1 (SHG) - 2 (SHRR) High (+) Approx. 4.5 V
Normal Approx. 2.5 V
Low (-) Approx. 0.5 V


E269066
4.594,1.01 4.854,1.604 true 5.042,1.74 4.729,2.24 true 5.604,1.271 5.26,1.594 true 0.073,0.042 0.385,0.198 0.313,0.156 10 *a 1.604,0.375 1.917,0.531 0.313,0.156 10 *b 0.792,1 1.104,1.156 0.313,0.156 10 *c 1.198,1.896 1.51,2.052 0.313,0.156 10 *d 1.771,0.021 2.083,0.177 0.313,0.156 10 *e 1.26,2.365 1.573,2.521 0.313,0.156 10 *f 1.031,0.438 1.448,0.656 0.417,0.219 10 60° 0.771,1.719 1.188,1.938 0.417,0.219 10 60° 1.49,0.844 1.906,1.063 0.417,0.219 10 45° 1.344,1.458 1.76,1.677 0.417,0.219 10 45° 4.521,2.25 5.135,2.448 0.615,0.198 10 SHRR 4.427,0.854 5.052,1.052 0.625,0.198 10 SHB 5.49,1.104 6.104,1.302 0.615,0.198 10 SHG
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly LH)
*b Low (-)
*c Normal *d High (+)
*e Stopper position at lowest vehicle height *f Stopper position at highest vehicle height


If the result is not as specified, replace the height control sensor sub-assembly LH.