Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050195 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84345 1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.

Attach the 2 claws to install a new stop light switch mounting adjuster.


Hide 84340 2.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E229767C01
2.042,1.823 2.01,1.542 false 1.188,1.865 1.104,1.417 false 0.521,1.49 0.781,1.427 false 0.344,1.427 0.656,1.583 0.313,0.156 10 *1 1.146,1.865 1.458,2.021 0.313,0.156 10 *2 1.99,1.833 2.302,1.99 0.313,0.156 10 *3
*1 Brake Pedal
*2 Stop Light Switch Mounting Adjuster
*3 Stop Light Switch Assembly


Install the stop light switch assembly to the adjuster until the switch body slightly touches the brake pedal.

NOTICE:

Do not depress the brake pedal.



b.
E229768C01
2.021,1.875 1.979,1.552 false 0.406,1.104 0.708,1.104 false 0.26,1.042 0.573,1.198 0.313,0.156 10 *1 0.979,1.76 1.292,1.917 0.313,0.156 10 *2 1.958,1.885 2.271,2.042 0.313,0.156 10 *3
*1 Shaft
*2 0.5 to 2.6 mm (0.0197 to 0.102 in.)
*3 Stop Light Switch Assembly


Rotate the stop light switch assembly clockwise so that the clearance is between 0.5 and 2.6 mm (0.0197 to 0.102 in.) as shown in the illustration.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

NOTICE:

Do not depress the brake pedal.



c.

Check the stop light switch assembly clearance.

Stop light switch clearance:

0.5 to 2.6 mm (0.0197 to 0.102 in.)



d.

Connect the connector to the stop light switch assembly.


Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY