Home › Drivetrain › GF1A TRANSFER / 4WD / AWD › TRANSFER OIL
RM3090E _52 Drivetrain _008760 GF1A TRANSFER / 4WD / AWD _0050208 TRANSFER OIL G

GF1A TRANSFER / 4WD / AWD  TRANSFER OIL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK TRANSFER OIL

a.

Stop the vehicle on a level surface.


b.
C277144

Using a 10 mm straight hexagon wrench and 10 x 12 mm long offset wrench, remove the No. 2 transfer case plug (for filler) and gasket.


c.
C278961C01
2.667,0.854 2.979,1.052 0.313,0.198 10 false *a
*a 0 to 5.0 mm (0 to 0.196 in.)


Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the No. 2 transfer case plug (for filler) hole.

If the result is not as specified, add transfer oil.

Oil grade:

Toyota Genuine Differential gear oil LT API GL-5 or equivalent


Viscosity:

SAE 75W-85


NOTICE:
·

When adding oil, pour it slowly.

·

Too much or too little oil will lead to transfer problems.




d.

If the oil level is low, refill oil after checking for oil leaks.


e.
C277145C01
0.698,4.458 0.563,4.458 0.563,4.458 0.365,4.177 true 0.99,3.99 1.073,4.313 1.073,4.313 1.198,4.313 true 1.49,4 1.625,4.365 1.625,4.365 1.76,4.365 true 0.771,4.375 1.083,4.573 0.313,0.198 10 *1 1.844,4.281 2.156,4.479 0.313,0.198 10 *2 1.271,4.229 1.583,4.427 0.313,0.198 10 *3
*1 10 mm Straight Hexagon Wrench
*2 12 mm Hexagon Socket Wrench
*3 10 x 12 mm Long Offset Wrench


Using a 10 mm straight hexagon wrench, 12 mm hexagon socket wrench and 10 x 12 mm long offset wrench, install a new gasket into the No. 2 transfer case plug (for filler) and then install the No. 2 transfer case plug (for filler).

Torque:
39 N*m (398 kgf*cm, 28 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a offset wrench is combined with a torque wrench (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:

When tightening, combine the offset wrench with the torque wrench so that they are in a straight line.