51441
1.REMOVE NO. 1 ENGINE UNDER COVER
51443
2.REMOVE REAR ENGINE UNDER COVER RH
12611
3.REMOVE NO. 1 ENGINE COVER
4.DRAIN ENGINE COOLANT
16470
5.REMOVE RADIATOR RESERVOIR ASSEMBLY
51217A
6.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH
16361A
7.REMOVE FAN AND GENERATOR V BELT
12156
8.REMOVE OIL PAN INSULATOR
12305
9.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
Remove the nut.
Loosen the 4 bolts and 2 nuts from the front engine mounting insulator and rear engine mounting insulator.
Loosen the bolts and nuts approximately 10 turns. Do not remove them.
Place a wooden block between a jack and the engine.
Make sure to set a jack as shown in the illustration. Do not place the jack on the oil pan sub-assembly.
Jack up the engine slightly.
Remove the 5 bolts, nut and engine mounting insulator sub-assembly RH.
Jacking up the engine slightly makes the engine mounting insulator sub-assembly RH easier to remove.
12341
10.REMOVE ENGINE MOUNTING SPACER
Remove the 2 bolts and engine mounting spacer.
16649B
11.REMOVE IDLER PULLEY COVER PLATE
16603
12.REMOVE NO. 1 IDLER PULLEY SUB-ASSEMBLY
16604
13.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
Remove the pulley bolt, No. 2 idler pulley cover plate and No. 2 idler pulley sub-assembly.
16100
14.REMOVE ENGINE WATER PUMP ASSEMBLY
Remove the 7 bolts, engine water pump assembly and gasket.