Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY › 2012.12–2015.10
RM3090E _52 Drivetrain _008761 DRIVE SHAFT / PROPELLER SHAFT _0050237 REAR DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42360M 1.INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH

a.

Install a new rear drive shaft inboard joint shaft snap ring LH.


Hide 42340B 2.INSTALL REAR DRIVE SHAFT ASSEMBLY LH

a.

Align the matchmarks and connect the rear drive shaft to the axle hub


b.

Apply MP grease to the splines of the rear drive shaft inboard joint assembly LH.


c.
C129504

Align the splines of the rear drive shaft inboard joint assembly LH and, using a brass bar and hammer, tap in the rear drive shaft assembly LH.

NOTICE:
·

Face the cutout section of the rear drive shaft inboard joint shaft snap ring LH downward.

·

Do not damage the oil seal during the insertion.

·

Do not strike the tip of the outboard joint with the hammer.



HINT:

Determine whether or not the rear drive shaft assembly LH is completely tapped in by checking for changes in sound or the reaction force of the brass bar.



Hide 41110 3.INSTALL DIFFERENTIAL CARRIER ASSEMBLY

Hide 4.CONNECT REAR SPEED SENSOR LH

Hide 42312B 5.INSTALL REAR AXLE SHAFT NUT LH

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 8.INSPECT AND ADJUST REAR WHEEL ALIGNMENT