Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY
RM3090E _52 Drivetrain _008761 DRIVE SHAFT / PROPELLER SHAFT _0050237 REAR DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42312B 2.REMOVE REAR AXLE SHAFT NUT LH

Hide 3.DISCONNECT REAR SPEED SENSOR LH

Hide 41110 4.DISCONNECT DIFFERENTIAL CARRIER ASSEMBLY

Hide 42340B 5.REMOVE REAR DRIVE SHAFT ASSEMBLY LH

a.
C231109C01
1.75,2.104 2.24,2.615 2.24,2.615 2.479,2.615 true 2.24,2.604 2.021,1.896 true 2.542,2.5 2.927,2.688 0.385,0.188 10 *a
*a Rib


With ribs:

Set the tip of the tire lever to the position on the rear drive shaft inboard joint assembly LH shown in the illustration. Then, using the ribbed part of the rear differential carrier assembly as a fulcrum, disconnect the rear drive shaft assembly LH.

NOTICE:

Do not scratch the rear drive shaft dust cover.



b.
C228112

Without ribs:

Set the tip of a wheel nut wrench to the position on the rear drive shaft inboard joint assembly LH shown in the illustration. Then, using a brass bar as a fulcrum, disconnect the rear drive shaft assembly LH.

NOTICE:

Do not scratch the rear drive shaft dust cover.



c.
C129489C01
1.781,0.646 2.417,0.417 2.417,0.417 1.844,0.885 true 2.417,0.417 2.917,0.417 true 3,0.333 3.198,0.51 0.198,0.177 10 *a
*a Matchmark


Put matchmarks on the rear drive shaft assembly LH and rear axle hub assembly.

NOTICE:

Do not use a punch to make the matchmarks.



d.

Using a plastic-faced hammer, remove the rear drive shaft assembly LH from the rear axle hub assembly.

NOTICE:
·

Be careful not to damage the boot, dust cover and speed sensor rotor.

·

Do not excessively push out the rear drive shaft assembly LH from the rear axle hub assembly.




Hide 42360M 6.REMOVE REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH

C129495

a.

Using a screwdriver, remove the rear drive shaft inboard joint shaft snap ring LH.