Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY
RM3090E _52 Drivetrain _008761 DRIVE SHAFT / PROPELLER SHAFT _0050239 PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  REMOVAL  


PROCEDURE

Hide 37100 1.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

a.
C127524

Remove the 2 bolts and 2 center No. 2 support bearing washers, and disconnect the propeller with center bearing shaft assembly.

NOTICE:
·

During the removal, do not exert excessive force on the universal joint.

·

When removing, transporting or storing the propeller with center bearing shaft assembly, do not allow the No. 2 joint angle to exceed 20°.




b.
C278923
1.75,1.333 1.167,1.833 1.167,1.833 1.76,1.219 true 1.167,1.833 0.333,1.833 true 0.104,1.719 0.417,1.917 0.313,0.198 10 *a
*a Matchmark


Place matchmarks on the differential carrier assembly and propeller with center bearing shaft assembly.


c.

Remove the 4 nuts and 4 washers, and disconnect the propeller with center bearing shaft assembly from the differential carrier assembly.


d.
C278924
1.51,1.104 0.833,0.417 0.833,0.417 1.552,1.073 true 0.833,0.417 0.667,0.417 false 0.5,0.302 0.813,0.5 0.313,0.198 10 *a
*a Matchmark


Place matchmarks on the transfer assembly and propeller with center bearing shaft assembly.


e.

Remove the 4 nuts and 4 washers, and disconnect the propeller with center bearing shaft assembly from the transfer assembly.