Home › Drivetrain › CLUTCH › CLUTCH PEDAL SWITCH
RM3090E _52 Drivetrain _008754 CLUTCH _0050269 CLUTCH PEDAL SWITCH G

CLUTCH  CLUTCH PEDAL SWITCH  INSPECTION  


PROCEDURE

Hide 88280C 1.INSPECT CLUTCH SWITCH ASSEMBLY

C127480
1.479,1.76 2.094,1.938 0.615,0.177 0.542,1.979 0.802,2.177 0.26,0.198 10 *a
*a 6.5 to 7.5 mm (0.256 to 0.295 in.)


a.

Check the resistance between the terminals when the switch is ON and OFF.

Standard Resistance:
Tester Connection Switch Position Specified Condition
1-2 ON (pushed) Below 1 Ω
1-2 OFF (not pushed) 10 kΩ or higher



Hide 2.INSPECT CLUTCH START SWITCH ASSEMBLY

C127475
0.615,1.615 0.854,1.802 0.24,0.188 10 *a
*a 7.65 to 8.35 mm (0.302 to 0.328 in.)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1-2 On (pushed) Below 1 Ω
1-2 Off (not pushed) 10 kΩ or higher


If the result is not as specified, replace the clutch start switch assembly.