Home › Drivetrain › EA64 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE ASSEMBLY › 2012.12–2015.10
RM3090E _52 Drivetrain _008755 EA64 MANUAL TRANSMISSION / TRANSAXLE _0050291 MANUAL TRANSAXLE ASSEMBLY A

EA64 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL MANUAL TRANSAXLE ASSEMBLY

a.

Align the input shaft assembly with the clutch disc assembly and install the manual transaxle assembly to the engine.

NOTICE:

Make sure that the dowel pins are not loose, bent, damaged or scratched and then install the manual transaxle assembly to the engine with the contact surfaces of the engine and transaxle flat against each other.



b.
C285126C01
0.573,0.094 0.885,0.292 0.313,0.198 10 false *a
*a Temporarily


Temporarily install the manual transaxle assembly with the bolt (*a).


c.
C116719N02
1.292,0.031 1.667,0.208 0.375,0.177 10 false B: 1 0.5,0.052 0.896,0.24 0.396,0.188 10 false B: 3 0.083,1.333 0.406,1.521 0.323,0.188 10 false A: 2

Tighten the 3 bolts labeled A and B in the order shown in the illustration, and then install the 2 bolts.

Torque:
for bolt A : 46 N*m (469 kgf*cm, 34 ft.*lbf)
for bolt B : 64 N*m (653 kgf*cm, 47 ft.*lbf)


Hide 12325A 5.INSTALL ENGINE MOUNTING BRACKET LH

HINT:

Perform this procedure only when replacement of the engine mounting bracket LH is necessary.


a.

Install the engine mounting bracket LH with the 4 bolts.

Torque:
64 N*m (653 kgf*cm, 47 ft.*lbf)


Hide 12321A 6.INSTALL REAR ENGINE MOUNTING BRACKET

a.

Temporarily install the rear engine mounting bracket with the 5 bolts.


b.
A272267N01
2.24,1.667 2.396,1.865 0.156,0.198 10 1 0.906,0.948 1.063,1.146 0.156,0.198 10 2 1.167,1.729 1.323,1.927 0.156,0.198 10 3 2.313,1.156 2.469,1.354 0.156,0.198 10 4 2.24,0.5 2.396,0.698 0.156,0.198 10 5

Tighten the 5 bolts of the rear engine mounting bracket in the order shown in the illustration.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


Hide 12311A 7.INSTALL FRONT ENGINE MOUNTING BRACKET

a.
A224433N01
2.354,0.771 2.51,0.969 0.156,0.198 10 2 1.927,0.208 2.083,0.406 0.156,0.198 10 3 1.771,1.865 1.927,2.063 0.156,0.198 10 1

Temporarily install the front engine mounting bracket with the 3 bolts.


b.

Tighten the 3 bolts of the front engine mounting bracket in the order shown in the illustration.

Torque:
64 N*m (653 kgf*cm, 47 ft.*lbf)


Hide 8.INSTALL ENGINE ASSEMBLY WITH MANUAL TRANSAXLE