Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR DRIVE UNIT
RM3090E _59 Vehicle Exterior _008794 DOOR / HATCH _0049525 POWER BACK DOOR DRIVE UNIT A

DOOR / HATCH  POWER BACK DOOR DRIVE UNIT  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

The spindle unit and upper bracket cannot be disassembled once they have been assembled. Therefore, when replacing the spindle or upper bracket make sure to replace the spindle, upper bracket and lower bracket as a set.


PROCEDURE

Hide 67939B 1.REMOVE BACK DOOR CENTER GARNISH

Hide 67938A 2.REMOVE BACK DOOR SIDE GARNISH LH

Hide 67937B 3.REMOVE BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure described for the LH side.


Hide 67750 4.REMOVE BACK DOOR TRIM BOARD ASSEMBLY

Hide 84280D 5.REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH

Hide 84270G 6.REMOVE POWER BACK DOOR SENSOR ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 68920 7.REMOVE POWER BACK DOOR UNIT ASSEMBLY SET LH

NOTICE:

The spindle unit and bracket cannot be disassembled once they have been assembled. Therefore, when replacing the spindle, upper bracket or lower bracket, make sure to replace the spindle, upper bracket and lower bracket as a set.


a.
B338185

Disconnect the connector and detach the clamp and grommet.


b.
B336843

Remove the 4 bolts and power back door unit assembly set LH.


Hide 68910A 8.REMOVE POWER BACK DOOR UNIT ASSEMBLY SET RH

HINT:

Use the same procedure described for the LH side.


Hide 68948 9.REMOVE BACK DOOR DAMPER STAY LOWER BRACKET LH

a.

Perform this procedure when replacing only the back door damper stay lower bracket LH.

i.
B345034

Move the protector cover until the pin can be seen.


ii.
B345035

Using a 3 mm pin punch and hammer, tap out the pin from the joint.


iii.

Remove the joint and protector cover.



Hide 68947 10.REMOVE BACK DOOR DAMPER STAY LOWER BRACKET RH

HINT:

Use the same procedure described for the LH side.