Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM3090E _58 Vehicle Interior _008788 SEAT BELT _0050327 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62312B 4.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 67918E 5.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332C 6.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 73233 7.REMOVE OUTER LAP BELT ANCHOR COVER

a.
B334884

Using a screwdriver, detach the 3 claws to remove the outer lap belt anchor cover.

HINT:

Tape the screwdriver tip before use.



Hide 8.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH

a.
B334885

Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly LH.


Hide 62414A 9.REMOVE LOWER CENTER PILLAR GARNISH LH

Hide 62412 10.REMOVE CENTER PILLAR GARNISH LH

Hide 73220 11.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

a.
B334886

Remove the nut and shoulder anchor of the front seat outer belt assembly LH.


b.
B334887C01
1.354,0.927 1.656,0.521 false 1.656,0.365 1.969,0.563 0.313,0.198 10 *1
*1 Protective Tape


Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



c.
B334888

Remove the bolt.


d.

Detach the 2 claws to remove the front seat outer belt assembly LH.


Hide 73210 12.REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH (for Front Passenger Seat Belt with Selectable Force Limiter)

a.
B334886

Remove the nut and shoulder anchor of the front seat outer belt assembly RH.


b.
B339093C01
1.292,0.865 1.563,0.604 false 1.583,0.458 1.896,0.615 0.313,0.156 10 *1
*1 Protective Tape


Using a screwdriver, pull out the 2 locking buttons in the direction shown by the arrow in the illustration to release the 2 locks and disconnect the pretensioner connector and selectable force limiter connector as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



c.
B339094

Remove the bolt.


d.

Detach the 2 claws to remove the front seat outer belt assembly RH.


Hide 73200A 13.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

a.
B334890

Remove the 2 bolts.


b.

Detach the guide and remove the front shoulder belt anchor adjuster assembly.