Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER SYSTEM › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008794 DOOR / HATCH _0050373 BACK DOOR CLOSER SYSTEM U

DOOR / HATCH  BACK DOOR CLOSER SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Back Door, Main Body or Entry&Start* / Data List.

*: w/ Entry and Start System



e.

According to the display on the GTS, read the Data List.

Body Electrical > Back Door > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Door Lock Status Back door condition signal Lock or Unlock Lock: Back door locked
Unlock: Back door unlocked
-
Half Latch SW Latch switch signal ON or OFF ON: Back door lock motor open-latched
OFF: Back door lock motor full-latched or half-latched
-
Closer Position SW Sector switch signal ON or OFF ON: Back door lock center gear in center position
OFF: Back door lock center gear not in center position
-
Courtesy SW Back door courtesy switch signal ON or OFF ON: Back door open
OFF: Back door closed
-
IG SW Ignition switch signal ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
"OFF" is also displayed for this item when the ignition switch is ACC.
#Codes The number of DTCs Min.: 0
Max.: 255
The number of DTCs -
Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Back Door Open Back door condition signal Permit or Prohibit Permit: Back door unlocked
Prohibit: Back door locked
-
Back Door Open Handle SW Back door opener switch assembly signal ON or OFF ON: Back door opener switch assembly on
OFF: Back door opener switch assembly off
-
Body Electrical > Entry&Start > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Tr/B-Door Lock SW Back door opener switch assembly signal ON or OFF ON: Back door opener switch assembly on
OFF: Back door opener switch assembly off
-