Home › Vehicle Interior › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY
RM3090E _58 Vehicle Interior _008788 SEAT BELT _0050328 REAR SEAT INNER BELT ASSEMBLY G

SEAT BELT  REAR SEAT INNER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 73380D 1.INSPECT REAR SEAT INNER BELT ASSEMBLY LH

a.
B332791
0.229,0.208 0.542,0.365 0.313,0.156 10 *a
*a Component without harness connected
(Rear Seat Inner Belt Assembly LH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Rear LH seat belt not fastened Below 1 Ω
1 - 2 Rear LH seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the rear seat inner belt assembly LH.


Hide 73380D 2.INSPECT REAR SEAT INNER BELT ASSEMBLY RH

a.
B332791
0.229,0.208 0.542,0.365 0.313,0.156 10 *a
*a Component without harness connected
(Rear Seat Inner Belt Assembly RH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Rear RH seat belt not fastened Below 1 Ω
1 - 2 Rear RH seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the rear seat inner belt assembly RH.


Hide 73330C 3.INSPECT REAR CENTER SEAT LAP TYPE BELT ASSEMBLY RH

a.
B339079
0.146,0.125 0.458,0.323 0.313,0.198 10 *a
*a Component without harness connected
(Rear Center Seat Lap Type Belt Assembly RH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Rear center seat belt not fastened Below 1 Ω
1 - 2 Rear center seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the rear center seat lap type belt assembly RH.