Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050509 AIRBAG CUT-OFF SWITCH G

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG CUT-OFF SWITCH  INSPECTION  


PROCEDURE

Hide 69065 1.INSPECT AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

a.
C234623
2.49,0.688 2.875,0.448 true 2.479,0.823 2.865,0.979 true 0.135,0.094 0.448,0.25 0.313,0.156 10 *a 2.896,0.365 3.375,0.552 0.479,0.188 10 MSW+ 2.896,0.917 3.375,1.094 0.479,0.177 10 MSW-
*a Component without harness connected
(Airbag Cut Off Switch Cylinder Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (MSW+) - 1 (MSW-) Airbag cut off switch cylinder sub-assembly in ON 360 to 440 Ω
2 (MSW+) - 1 (MSW-) Airbag cut off switch cylinder sub-assembly in OFF 90 to 110 Ω


If the result is not as specified, replace the airbag cut off switch cylinder sub-assembly.