Home › Vehicle Interior › SEAT › LUMBAR SWITCH
RM3090E _58 Vehicle Interior _008433 SEAT _0050535 LUMBAR SWITCH G

SEAT  LUMBAR SWITCH  INSPECTION  


PROCEDURE

Hide 84920 1.INSPECT POWER SEAT SWITCH ASSEMBLY

B239575
2.573,1.115 2.083,1.115 false 1.438,1.125 0.979,1.125 false 2.094,3.823 1.948,3.385 false 2.073,3.385 2.417,3.823 false 1.229,3.813 1.583,3.385 false 1.646,3.833 1.813,3.385 false 1.156,3.813 1.313,4.01 0.156,0.198 10 B 1.594,3.823 1.75,4.021 0.156,0.198 10 H 2.063,3.823 2.219,4.021 0.156,0.198 10 E 2.417,3.823 2.573,4.021 0.156,0.198 10 R 0.823,1.042 1.135,1.198 0.313,0.156 10 *1 2.615,1.031 2.927,1.188 0.313,0.156 10 *2 0.677,2.583 0.99,2.74 0.313,0.156 10 *a
*1 Hold Switch
*2 Release Switch
*a Component without harness connected
(Power Seat Switch Assembly)


a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (B) - 3 (H) Hold switch on Below 1 Ω
2 (E) - 1 (R)
2 (E) - 3 (H) Neutral Below 1 Ω
2 (E) - 1 (R)
2 (E) - 3 (H) Release switch on Below 1 Ω
5 (B) - 1 (R)


If the result is not as specified, replace the power seat switch assembly.