Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008793 SLIDING ROOF / CONVERTIBLE _0050547 SLIDING ROOF SWITCH ASSEMBLY G

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT ASSEMBLY (SLIDING ROOF SWITCH ASSEMBLY)

a.

Remove the map light assembly (sliding roof switch assembly).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.
B338944C01
2.052,2.885 2.396,2.885 false 1.906,2.875 2.313,2.542 2.313,2.542 2.448,2.542 false 1.656,2.875 1.49,2.375 1.49,2.375 1.344,2.375 false 1.771,2.865 2.031,2.365 2.031,2.365 2.167,2.365 false 1.531,2.875 1.031,2.573 1.031,2.573 0.854,2.573 false 0.417,2.292 0.729,2.448 0.313,0.156 10 *a 0.875,2.302 1.49,2.469 0.615,0.167 10 DOWN 0.615,2.5 0.99,2.667 0.375,0.167 10 UP 2.24,2.281 2.719,2.458 0.479,0.177 10 OPN 2.51,2.458 2.906,2.635 0.396,0.177 10 CLS 2.448,2.802 2.885,2.969 0.438,0.167 10 GND3
*a Component without harness connected
(Map Light Assembly (Sliding Roof Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (GND3) - 5 (UP) UP switch is pressed Below 1 Ω
1 (GND3) - 5 (UP) UP switch is not pressed 10 kΩ or higher
1 (GND3) - 4 (DOWN) DOWN switch is pressed Below 1 Ω
1 (GND3) - 4 (DOWN) DOWN switch is not pressed 10 kΩ or higher
1 (GND3) - 3 (OPN) OPEN switch is pressed Below 1 Ω
1 (GND3) - 3 (OPN) OPEN switch is not pressed 10 kΩ or higher
1 (GND3) - 2 (CLS) CLOSE switch is pressed Below 1 Ω
1 (GND3) - 2 (CLS) CLOSE switch is not pressed 10 kΩ or higher


If the result is not as specified, replace the map light assembly (sliding roof switch assembly).


c.

Install the map light assembly (sliding roof switch assembly).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>INSTALLATION