Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050512 KNEE AIRBAG ASSEMBLY N

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY  DISPOSAL  


CAUTION / NOTICE / HINT

CAUTION:

Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment.


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with your bare hands to discharge static electricity before performing this procedure.

·

Never dispose of a lower No. 1 instrument panel airbag assembly with an undeployed airbag.

·

The airbag produces an exploding sound when it is deployed, so perform the operation outdoors and where it will not create a nuisance to nearby residents.

·

When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool). Perform the operation in a place away from electrical noise.

·

When deploying the airbag, perform the operation at least 10 m (32.8 ft.) away from the lower No. 1 instrument panel airbag assembly.

·

The lower No. 1 instrument panel airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

·

Use gloves and safety glasses when handling a lower No. 1 instrument panel airbag assembly with a deployed airbag.

·

Do not apply water etc. to a lower No. 1 instrument panel airbag assembly with a deployed airbag.

·

Always wash your hands with water after completing the operation.



HINT:

When scrapping a vehicle equipped with an SRS or disposing of the lower No. 1 instrument panel airbag assembly, be sure to deploy the airbag first in accordance with the procedure described below. If any abnormality occurs with the airbag deployment, contact the Service Dept. of the distributor.


Hide 73900 2.DISPOSE OF LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (When Installed in Vehicle)

NOTICE:
·

When disposing of the lower No. 1 instrument panel airbag assembly, never use the customer's vehicle to deploy the airbag.

·

Be sure to observe the following procedure when deploying the airbag.



HINT:

Prepare a battery as the power source to deploy the airbag.


a.
C110371N26
0.875,1.208 0.833,0.635 0.833,0.635 0.646,0.635 false 0.365,0.563 0.823,0.76 0.458,0.198 10 SST

Check the function of SST.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD(for Single Type)>DISPOSAL

SST
09082-00700  



c.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



d.

Remove the No. 1 instrument panel under cover sub-assembly.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL


e.

Disconnect the lower No. 1 instrument panel airbag connector.

i.

Using a screwdriver with the tip wrapped with protective tape, disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.




f.

Install SST.

CAUTION:

Check that there is no looseness in the lower No. 1 instrument panel airbag assembly.


i.
B339304N01
2.063,1.198 2.656,1.438 true 2.104,1.615 2.646,1.458 true 1.24,1.927 1.583,1.979 true 1.688,1.896 2.146,2.094 0.458,0.198 10 SST 2.771,1.385 3.229,1.583 0.458,0.198 10 SST

Connect the SST connector to the lower No. 1 instrument panel airbag assembly.

SST
09082-00700  09082-00802  (09082-10801, 09082-20801)

NOTICE:

To avoid damaging the SST connector or wire harness, do not lock the secondary lock of the twin lock.



ii.
B340835C01
0.729,1.521 0.646,0.917 0.646,0.917 0.521,0.917 false 1.75,0.865 2.042,0.667 false 2.073,0.542 2.385,0.698 0.313,0.156 10 *1 1.604,1.896 1.917,2.052 0.313,0.156 10 *a 0.208,0.844 0.667,1.042 0.458,0.198 10 SST
*1 Battery
*a 10 m or more


Move SST at least 10 m (32.8 ft.) away from the front side window of the vehicle.


iii.

While maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.

NOTICE:

Take care not to damage the SST wire harness.



iv.

Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.



g.

Deploy the airbag.

i.

Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.


ii.

Press the SST activation switch and deploy the airbag.

CAUTION:
·

Before deployment, make sure that no one is near the vehicle.

·

The lower No. 1 instrument panel airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

·

Use gloves and safety glasses when handling a lower No. 1 instrument panel airbag assembly with a deployed airbag.

·

Do not apply water etc. to a lower No. 1 instrument panel airbag assembly with a deployed airbag.

·

Always wash your hands with water after completing the operation.



HINT:

The airbag is deployed as the LED of the SST activation switch comes on.




Hide 73900 3.DISPOSE OF LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (When not Installed in Vehicle)

NOTICE:

Be sure to observe the following procedure when deploying the airbag.


HINT:

Prepare a battery as the power source to deploy the airbag.


a.
C110371N26
0.875,1.208 0.833,0.635 0.833,0.635 0.646,0.635 false 0.365,0.563 0.823,0.76 0.458,0.198 10 SST

Check the function of SST.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD(for Single Type)>DISPOSAL

SST
09082-00700  


b.

Remove the lower No. 1 instrument panel airbag assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>KNEE AIRBAG ASSEMBLY>REMOVAL

CAUTION:
·

Before removing the lower No. 1 instrument panel airbag assembly, wait at least 90 seconds after turning the ignition switch off and disconnecting the cable from the negative (-) battery terminal.

·

When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.




c.
B104882C28
1.99,1.594 1.99,1.25 false 2.656,0.51 2.969,0.667 0.313,0.156 10 *a 1.917,1.625 2.229,1.781 0.313,0.156 10 *b
*a Wire Diameter
*b Stripped Wire Section


Using braided wire, tie down the lower No. 1 instrument panel airbag assembly to an unneeded tire.

Wire:
Stripped wire section:

1.25 mm2 (0.0019 in.2) or more


CAUTION:

If the wire harness is too thin or an alternative object is used to tie down the lower No. 1 instrument panel airbag assembly, it may snap when the airbag is deployed. Always use a wire for vehicle use with an area of at least 1.25 mm2 (0.0019 in.2).


HINT:

To calculate the area of the stripped wire section:

Area = 3.14 x (Diameter)2 / 4


i.

Position the lower No. 1 instrument panel airbag assembly inside the tire with the airbag deployment side facing inside.

Minimum tire size:

Must exceed the following dimensions

Width:

185 mm (7.28 in.)

Inner diameter:

360 mm (1.18 ft.)


CAUTION:
·

Make sure that the wires are tight. If there is slack in the wires, the lower No. 1 instrument panel airbag assembly may break loose when the airbag is deployed.

·

Always tie down the lower No. 1 instrument panel airbag assembly with the airbag deployment side facing inside the tire as shown in the illustration.



NOTICE:

The tires may be damaged by the airbag deployment, so use unneeded tires.


B339305C01
2.563,2.531 2.875,2.688 0.313,0.156 10 *a 2.938,0.854 3.25,1.01 0.313,0.156 10 *b
*a Width *b Inner Diameter




d.

Install SST.

i.
B339306N01
0.802,1.448 1.01,1.135 false 1.156,1.625 1.021,1.135 false 0.885,0.969 1.344,1.167 0.458,0.198 10 SST

After connecting the following SST to each other, connect them to the lower No. 1 instrument panel airbag assembly.

SST
09082-00802  (09082-10801, 09082-20801)



e.

Place the tires.

i.
B339307C01
2.667,1.49 2.979,1.646 0.313,0.156 10 *1 2.656,0.396 2.969,0.552 0.313,0.156 10 *1
*1 Tires (2 or more)


Place at least 2 tires under the tire to which the lower No. 1 instrument panel airbag assembly is tied.


ii.

Place at least 2 tires onto the tire to which the lower No. 1 instrument panel airbag assembly is tied. The top tire should have a wheel installed.

NOTICE:
·

Do not place the SST connector under the tire because it could be damaged.

·

The tires and wheel may be damaged by the airbag deployment, so use unneeded tires and wheels.




iii.
B105087

Tie the tires together with the 2 wires.

CAUTION:

Make sure that the wires are tight. Looseness in the wires results in the tires breaking loose when the airbag is deployed.




f.

Install SST.

i.
B339308C01
0.458,2.99 0.458,2.667 false 1.563,2.104 1.469,1.906 false 2.604,0.417 2.448,0.417 2.448,0.417 2.385,1.208 true 2.635,0.333 2.823,0.5 0.188,0.167 10 *1 1.531,2.135 1.844,2.302 0.313,0.167 10 *2 1.26,2.927 1.573,3.083 0.313,0.156 10 *a 0.333,3.01 0.667,3.24 0.333,0.229 10 SST
*1 Lower No. 1 Instrument Panel Airbag Assembly
*2 Battery
*a 10 m or more


Connect the SST connector.

SST
09082-00700  

NOTICE:

To avoid damaging the SST connector or wire harness, do not lock the secondary lock of the twin lock. Also, secure some slack for the SST wire harness inside the tire.



ii.

Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.



g.

Deploy the airbag.

i.

Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.


ii.

Check that no one is within a 10 m (32.8 ft.) radius of the wheel to which the lower No. 1 instrument panel airbag assembly is tied.


iii.

Press the SST activation switch and deploy the airbag.

CAUTION:

Before deployment, make sure that no one is near the airbag.


HINT:

The airbag is deployed as the LED of the SST activation switch comes on.




h.

Dispose of the lower No. 1 instrument panel airbag assembly.

CAUTION:
·

The lower No. 1 instrument panel airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

·

Use gloves and safety glasses when handling a lower No. 1 instrument panel airbag assembly with a deployed airbag.

·

Do not apply water etc. to a lower No. 1 instrument panel airbag assembly with a deployed airbag.

·

Always wash your hands with water after completing the operation.



i.

Remove the lower No. 1 instrument panel airbag assembly from the wheel.


ii.

Place the lower No. 1 instrument panel airbag assembly in a plastic bag, tie it tightly and dispose of it according to local regulations.