Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM(w/ Rain Sensor)
RM3090E _59 Vehicle Exterior _008795 WIPER / WASHER _0050248 WIPER AND WASHER SYSTEM(w/ Rain Sensor) J

WIPER / WASHER  WIPER AND WASHER SYSTEM(w/ Rain Sensor)  Headlight Signal Circuit  


DESCRIPTION

The headlight cleaner control relay detects the status of the low beam headlights.

WIRING DIAGRAM

E270958E01
0.396,0.49 2.229,0.688 1.833,0.198 10 from Battery 2.604,1.281 3.219,1.479 0.615,0.198 10 H-LP 1.979,1.906 4.583,2.104 2.604,0.198 10 to Headlight Unit 4.635,2.188 7.01,2.792 2.375,0.604 10 to Main Body ECU (Multiplex Network Body ECU) 5.479,1.25 5.938,1.448 0.458,0.198 10 A48 5.49,1.406 6.615,1.76 1.125,0.354 10 Headlight Cleaner Control Relay 5.552,0.5 7.156,0.719 1.604,0.219 10 HDLO 5.333,0.396 5.792,0.594 0.458,0.198 10 1 1.979,0.385 2.438,0.583 0.458,0.198 10 1 3.417,0.385 3.875,0.583 0.458,0.198 10 2 3.406,0.802 3.865,1 0.458,0.198 10 3 2,0.823 2.458,1.021 0.458,0.198 10 5

CAUTION / NOTICE / HINT

NOTICE:

First check that the low beam headlights operate normally.


PROCEDURE

1.CHECK HEADLIGHT CLEANER CONTROL RELAY
a.
E270107C01
0,0 0.313,0.156 0.313,0.156 10 *a
*a Front view of wire harness connector
(to Headlight Relay)


Remove the headlight relay from the No. 1 engine room relay block and junction block assembly.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Headlight relay terminal 2 - Body ground Light control switch in head position Below 1 V
Light control switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP] - HEADLIGHT CLEANER CONTROL RELAY)
2.CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP] - HEADLIGHT CLEANER CONTROL RELAY)
a.

Remove the headlight relay from the No. 1 engine room relay block and junction block assembly.


b.

Disconnect the A48 headlight cleaner control relay connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Headlight relay terminal 2 - A48-1 (HDLO) Always Below 1 Ω
Headlight relay terminal 2 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE HEADLIGHT CLEANER CONTROL RELAY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR