Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0047060 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)  Taillight Relay Circuit  


DESCRIPTION

This is the power source circuit of the clearance warning ECU assembly.

WIRING DIAGRAM

E270571E01
4.167,1.906 4.625,2.104 0.458,0.198 10 G33 4.146,2.115 6.594,2.344 2.448,0.229 10 Clearance Warning ECU Assembly 4.917,1.229 5.229,1.427 0.313,0.198 10 TL 4.625,1.063 4.938,1.26 0.313,0.198 10 20 0.75,1.188 1.979,1.385 1.229,0.198 10 from PANEL Fuse

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK TAILLIGHT
a.

Turn the light control switch to the TAIL position.


b.

Check that the taillight turns on.

OK:

Taillight turns on.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)

NG

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)
a.
E270561C01
1.5,0.219 1.896,0.479 0.396,0.26 1.573,1.75 1.979,1.177 false 0.094,0.094 0.406,0.292 0.313,0.198 10 *a 1.573,0.26 2.031,0.458 0.458,0.198 10 G33 1.365,1.677 1.677,1.875 0.313,0.198 10 TL
*a Front view of wire harness connector
(to Clearance Warning ECU Assembly)


Disconnect the G33 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G33-20 (TL) - Body ground Ignition switch ON, light control switch TAIL 11 to 14 V
Ignition switch ON, light control switch off Below 1 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR