Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0050589 NOISE FILTER G

AUDIO / VIDEO  NOISE FILTER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 86011Q 1.INSPECT RADIO SETTING CONDENSER

a.

With the radio setting condenser installed, check that there is no looseness or other abnormalities.


b.

Remove the bolt.


c.

Detach the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.


d.
E230106
1.963,0.576 2.428,0.576 false 2.088,1.588 2.541,1.425 false 1.348,1.589 0.816,1.427 false 2.443,0.492 2.553,0.649 0.111,0.157 10 3 2.554,1.33 2.665,1.487 0.111,0.157 10 2 0.707,1.317 0.817,1.474 0.111,0.157 10 1 0.062,0.075 0.269,0.232 0.207,0.157 10 *a
*a Radio Setting Condenser


Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2
·

Ignition switch off

·

Window defogger turned off


10 kΩ or higher
3 - Body ground Below 1 Ω


Standard Voltage:
Tester Connection Condition Specified Condition
1 - Body ground
·

Ignition switch ON

·

Window defogger turned off


Below 1 V
1 - Body ground
·

Ignition switch ON

·

Window defogger turned on


11 to 14 V