Home › Drivetrain › CLUTCH › CLUTCH UNIT(for 3ZR-FE, 3ZR-FAE)
RM3090E _52 Drivetrain _008754 CLUTCH _0050768 CLUTCH UNIT(for 3ZR-FE, 3ZR-FAE) G

CLUTCH  CLUTCH UNIT(for 3ZR-FE, 3ZR-FAE)  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

C205071

a.

Using a vernier caliper, measure the rivet head depth.

Minimum rivet depth:

0.3 mm (0.0118 in.)


If the depth is less than the minimum, replace the clutch disc assembly.


b.

Install the clutch disc assembly onto the manual transaxle assembly.

HINT:

Insert the clutch disc assembly in the correct direction.



c.
C200455

Using a dial gauge, measure the clutch disc assembly runout.

Maximum runout:

0.8 mm (0.0314 in.)


If the runout is more than the maximum, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

C200454
0.252,0.533 0.407,0.706 0.155,0.174 10 A 0.961,0.29 1.116,0.464 0.155,0.174 10 B

a.

Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

Maximum depth A:

0.5 mm (0.0196 in.)


Maximum width B:

6.0 mm (0.236 in.)


If the depth or width is more than the maximum, replace the clutch cover assembly.


Hide 13405 3.INSPECT FLYWHEEL SUB-ASSEMBLY

C199334

a.

Using a dial gauge, check the flywheel sub-assembly runout.

Maximum runout:

0.1 mm (0.00393 in.)


If the runout is more than the maximum, replace the flywheel sub-assembly.