Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH › 2012.12–2013.11
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0050790 LANE DEPARTURE ALERT SWITCH G

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  INSPECTION  


PROCEDURE

Hide 83950M 1.INSPECT TELLTALE LIGHT ASSEMBLY (LANE DEPARTURE ALERT SWITCH)

a.
B339082C01
1.865,1.104 2.229,0.49 true 2.417,1.865 2.646,1.427 true 0.115,0.146 0.427,0.302 0.313,0.156 10 false *a 2.26,0.385 2.719,0.583 0.458,0.198 10 false ECU 2.365,1.885 2.823,2.083 0.458,0.198 10 false E
*a Component without harness connected
(Telltale Light Assembly (Lane Departure Alert Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (ECU) - 13 (E) LDA switch pushed Below 1 Ω
6 (ECU) - 13 (E) LDA switch not pushed 10 kΩ or higher


If the result is not as specified, replace the telltale light assembly (lane departure alert switch).