Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)
RM3090E _59 Vehicle Exterior _008792 WINDOW / GLASS _0050246 POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) is operated by the power window regulator master switch assembly. The front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) has motor and ECU functions.

When the ECU determines that the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) has not been initialized, DTC B2313 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2313 Glass Position Initialization Incomplete Either condition is met:
·

Front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) not initialized

·

Front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) is malfunctioning

·

Battery disconnected when ignition switch is ON


·

Front power window regulator motor assembly LH (for LHD) not initialized

·

Front power window regulator motor assembly RH (for RHD) not initialized

·

Front power window regulator motor assembly LH (for LHD)

·

Front power window regulator motor assembly RH (for RHD)



CAUTION / NOTICE / HINT

NOTICE:
·

DTC B2313 is stored in the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD).

·

If the battery is disconnected while the ignition switch is ON, DTC B2313 is stored.

·

If the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) has been replaced with a new one, initialize the power window control system.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>INITIALIZATION



PROCEDURE

1.PERFORM INITIALIZATION
a.

Initialize the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD).

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Turn the ignition switch off.


b.

Wait for at least 10 seconds, and then turn the ignition switch to ON.


c.

Check for DTCs.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>DTC CHECK / CLEAR

Body Electrical > D-Door Motor > Trouble Codes
50001 124

Result:
Proceed to
DTC B2313 is not output
DTC B2313 is output (for LHD)
DTC B2313 is output (for RHD)



DTC B2313 is not output

END (PROBLEM DUE TO INITIALIZATION FAILURE)

DTC B2313 is output (for LHD)

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

DTC B2313 is output (for RHD)

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH