Home › Drivetrain › K111F MULTIDRIVE / CVT › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM3090E _52 Drivetrain _009408 K111F MULTIDRIVE / CVT _0051011 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM D

K111F MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  CHECK MODE PROCEDURE  


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are stored with 1 trip detection logic.



CHECK MODE PROCEDURE


a.

Make sure that the following conditions are met:

i.

Battery positive voltage 11 V or higher.


ii.

Throttle valve fully closed.


iii.

Shift lever in P or N.


iv.

A/C turned off.



b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.

Powertrain > Engine and ECT > Utility
Tester Display
Check Mode
50005 234 1

f.
C140840
0.333,0.719 0.604,0.917 0.271,0.198 10 false ON 0.323,1.51 0.677,1.708 0.354,0.198 10 false OFF 2,0.448 3.01,0.646 1.01,0.198 10 false 0.13 sec. 1.906,1.771 2.802,1.969 0.896,0.198 10 false 0.13 sec.

Check that the MIL flashes as shown in the illustration.

NOTICE:
·

All DTCs and freeze frame data will be cleared if: 1) the GTS is used to change the ECM from normal mode to check mode or vice versa; or 2) during check mode, the ignition switch is turned from ON to ACC or off.

·

Before changing to check mode, make notes of the DTCs and freeze frame data.




g.

Start the engine. The MIL should turn off after the engine starts.


h.

Simulate the conditions of the malfunction described by the customer.


i.

After simulating the malfunction conditions, use the GTS to check the DTC and freeze frame data.