Home › Drivetrain › K111F MULTIDRIVE / CVT › PARK / NEUTRAL POSITION SWITCH
RM3090E _52 Drivetrain _009408 K111F MULTIDRIVE / CVT _0051021 PARK / NEUTRAL POSITION SWITCH G

K111F MULTIDRIVE / CVT  PARK / NEUTRAL POSITION SWITCH  INSPECTION  


PROCEDURE

Hide 84540 1.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

C193931
1.156,0.927 0.896,0.469 false 1.344,0.927 1.26,0.469 false 1.615,0.927 1.594,0.469 false 1.979,0.927 2.26,0.469 false 1.25,1.51 0.969,1.906 false 1.427,1.51 1.302,1.906 false 1.802,1.51 1.802,1.906 false 0.083,0.073 0.396,0.323 0.313,0.25 10 *a 1.156,0.25 1.375,0.406 0.219,0.156 10 PL 0.76,0.25 0.896,0.406 0.135,0.156 10 B 0.854,1.938 0.99,2.094 0.135,0.156 10 L 1.188,1.938 1.406,2.094 0.219,0.156 10 NL 1.708,1.938 1.927,2.094 0.219,0.156 10 DL 1.521,0.25 1.781,0.406 0.26,0.156 10 RL 2.229,0.25 2.448,0.406 0.219,0.156 10 RB
*a Component without harness connected
(Park/Neutral Position Switch Assembly)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (RB) - 3 (PL) Shift lever in P Below 1 Ω
4 (B) - 9 (L) Shift lever in P Below 1 Ω
1 (RB) - 2 (RL) Shift lever in R Below 1 Ω
1 (RB) - 8 (NL) Shift lever in N Below 1 Ω
4 (B) - 9 (L) Shift lever in N Below 1 Ω
1 (RB) - 7 (DL) Shift lever in D, M, "+" or "-" Below 1 Ω
1 (RB) - 3 (PL) Shift lever not in P 10 kΩ or higher
4 (B) - 9 (L) Shift lever not in P 10 kΩ or higher
1 (RB) - 2 (RL) Shift lever not in R 10 kΩ or higher
1 (RB) - 8 (NL) Shift lever not in N 10 kΩ or higher
4 (B) - 9 (L) Shift lever not in N 10 kΩ or higher
1 (RB) - 7 (DL) Shift lever not in D, M, "+" or "-" 10 kΩ or higher


If the result is not as specified, replace the park/neutral position switch assembly.