Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY(for 2WD) › 2012.12–2015.10
RM3090E _52 Drivetrain _008761 DRIVE SHAFT / PROPELLER SHAFT _0050235 FRONT DRIVE SHAFT ASSEMBLY(for 2WD) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 2WD)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C116430

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no severe play in the radial direction of the inboard joint.


d.

Check the 2 joint boots for damage.


e.
C201654C01
0.104,1.802 0.635,1.99 0.531,0.188 10 *B 0.104,0.292 0.635,0.479 0.531,0.188 10 *A 1.406,1.542 1.74,1.875 0.333,0.333 10 (A) 1.427,3.063 1.75,3.26 0.323,0.198 10 (A)
*A for LH Side
*B for RH Side


Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.

Length (A):
Item Length
for 1AD-FTV (Manual Transaxle) LH Side 553.6 mm (1.82 ft.)
RH Side 932.4 mm (3.06 ft.)
for 2AR-FE (Automatic Transaxle) LH Side 577.6 mm (1.89 ft.)
RH Side 914.4 mm (3.00 ft.)
for 2AR-FE (Manual Transaxle) LH Side 583.6 mm (1.91 ft.)
RH Side 906.4 mm (2.97 ft.)
for 3ZR-FE (Manual Transaxle) LH Side 594.6 mm (1.95 ft.)
RH Side 893.4 mm (2.93 ft.)
for 3ZR-FE (CVT) LH Side 591.2 mm (1.94 ft.)
RH Side 890.0 mm (2.92 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.


If the boots are stretched or contracted, correct them.