Use the same procedure for RHD vehicles and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE CONSOLE BOX ASSEMBLY
2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the shift lever assembly.
| *1 | Stopper |
| *2 | Nut |
Pull out the stopper of the transmission control cable assembly.
Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.
Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.
3.REMOVE SHIFT LEVER ASSEMBLY
Disconnect the 2 connectors and 4 clamps from the shift lever assembly.
| *A | for LHD | *B | for RHD |
Remove the 4 bolts and shift lever assembly.