Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › RELAY
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0051154 RELAY G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK STOP LIGHT CONTROL RELAY (STOP LP)

a.

Remove the stop light control relay (STOP LP) from the engine room relay block.


b.
C260229
2.01,0.583 1.813,0.302 false 2.323,0.583 2.323,0.271 false 2.615,0.594 2.823,0.292 false 2.521,1.125 2.927,1.125 false 2.51,1.604 2.906,1.604 false 0.323,1.417 0.479,1.615 0.156,0.198 10 1 1.719,0.083 1.875,0.281 0.156,0.198 10 1 1.313,1.406 1.469,1.604 0.156,0.198 10 2 0.323,0.875 0.479,1.073 0.156,0.198 10 3 2.865,0.135 3.021,0.333 0.156,0.198 10 2 2.979,1.531 3.135,1.729 0.156,0.198 10 3 0.938,0.406 1.094,0.604 0.156,0.198 10 4 2.292,0.063 2.448,0.26 0.156,0.198 10 4 1.313,0.875 1.469,1.073 0.156,0.198 10 5 2.99,1.031 3.146,1.229 0.156,0.198 10 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 Below 1 Ω
Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage applied to terminal 2 10 kΩ or higher
3 - 5 Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 10 kΩ or higher
Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage applied to terminal 2 Below 1 Ω


If the result is not as specified, replace the relay.


c.

Install the stop light control relay (STOP LP).