Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › 2012.12–2013.11
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0048748 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B157D  DAB Tuner Antenna Disconnected  


DESCRIPTION

This DTC is stored when a malfunction occurs in the antenna with holder assembly which is connected to the radio and display receiver assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
B157D DAB Tuner Antenna Disconnected The antenna with holder assembly is not connected.
·

Antenna cord sub-assembly

·

No. 2 antenna cord sub-assembly

·

No. 3 antenna cord sub-assembly

·

Roof antenna pole sub-assembly

·

Antenna with holder assembly

·

Radio and display receiver assembly



PROCEDURE

1.CHECK ANTENNA CORD SUB-ASSEMBLY

b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
No DTCs are output
DTCs are output



No DTCs are output

END (ANTENNA CORD SUB-ASSEMBLY IS DEFECTIVE)

DTCs are output

2.CHECK NO. 2 ANTENNA CORD SUB-ASSEMBLY
2.CHECK NO. 2 ANTENNA CORD SUB-ASSEMBLY
a.

Replace the No. 2 antenna cord sub-assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD(for Roof Side)>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
No DTCs are output
DTCs are output



No DTCs are output

END (NO. 2 ANTENNA CORD SUB-ASSEMBLY IS DEFECTIVE)

DTCs are output

3.CHECK NO. 3 ANTENNA CORD SUB-ASSEMBLY
3.CHECK NO. 3 ANTENNA CORD SUB-ASSEMBLY
a.

Replace the No. 3 antenna cord sub-assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD(for Roof Side)>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
No DTCs are output
DTCs are output



No DTCs are output

END (NO. 3 ANTENNA CORD SUB-ASSEMBLY IS DEFECTIVE)

DTCs are output

4.CHECK ROOF ANTENNA POLE SUB-ASSEMBLY
4.CHECK ROOF ANTENNA POLE SUB-ASSEMBLY
a.

Check that the roof antenna pole sub-assembly is securely installed.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA POLE>REMOVAL


Result:
Proceed to
The roof antenna pole sub-assembly is installed properly
The roof antenna pole sub-assembly is not installed properly



The roof antenna pole sub-assembly is installed properly

5.CHECK ANTENNA WITH HOLDER ASSEMBLY

The roof antenna pole sub-assembly is not installed properly

REPLACE ROOF ANTENNA POLE SUB-ASSEMBLY

5.CHECK ANTENNA WITH HOLDER ASSEMBLY
a.

Replace the antenna with holder assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA POLE>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
No DTCs are output
DTCs are output



No DTCs are output

END (ANTENNA WITH HOLDER ASSEMBLY IS DEFECTIVE)

DTCs are output

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY