Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY
RM3090E _52 Drivetrain _008761 DRIVE SHAFT / PROPELLER SHAFT _0050237 REAR DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT REAR DRIVE SHAFT ASSEMBLY

a.
C116430

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no severe play in the radial direction of the inboard joint.


d.

Check the 2 joint boots for damage.


e.
C127699
1.438,1.521 1.656,1.74 0.219,0.219 10 (A)

Check that the 2 joint boots are not stretched or contracted when the rear drive shaft assembly is at the standard length.

Length (A):

733.2 mm (2.40 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.


If the boots are stretched or contracted, correct them.