Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM3090E _59 Vehicle Exterior _008795 WIPER / WASHER _0050096 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT RAIN SENSOR

a.
E267170
1.948,1.354 2.448,1.656 false 1.583,1.354 1.073,1.688 false 0.135,0.156 0.448,0.354 0.313,0.198 10 *a 0.948,1.719 1.26,1.917 0.313,0.198 10 ES 2.396,1.677 2.76,1.875 0.365,0.198 10 SIG
*a Front view of wire harness connector
(to Rain Sensor)


Disconnect the rain sensor connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
4 (SIG) - Body ground Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (ES) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the harness or connector.


d.

Reconnect the rain sensor connector.


e.

Connect an oscilloscope to the rain sensor connector.


f.
E257042
1.969,0.958 2.521,0.406 false 1.802,0.958 1.115,0.406 false 0.156,0.177 0.469,0.375 0.313,0.198 10 *a 0.969,0.188 1.281,0.385 0.313,0.198 10 ES 2.438,0.198 2.875,0.406 0.438,0.208 10 MPX
*a Component with harness connected
(Rain Sensor)


Check for pulses.

OK
Tester Connection Condition Specified Condition
1 (MPX) - 2 (ES) Ignition switch ON Pulse generation

If the result is not as specified, replace the rain sensor.