Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 2AR-FE)
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0050515 COMPRESSOR(for 2AR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 2AR-FE)  DISASSEMBLY  


PROCEDURE

Hide 88688K 1.REMOVE COOLER COMPRESSOR BRACKET

a.

Disconnect the connector.


b.

Detach the connector clamp.


c.
E271003

Remove the screw and cooler compressor bracket.


Hide 88410 2.REMOVE MAGNET CLUTCH ASSEMBLY

a.
E271004
0.802,0.698 0.594,0.365 false 0.292,0.25 0.75,0.448 0.458,0.198 10 false SST 1.948,1.667 2.26,1.823 0.313,0.156 10 false *a 0,1.292 0.313,1.448 0.313,0.156 10 false *b
*a Hold
*b Turn


Clamp the cooler compressor in a vise between aluminum plates.


b.

Using SST, hold the magnet clutch hub.

SST
09985-00270  


c.

Remove the bolt, magnet clutch hub and magnet clutch washer(s).

HINT:

There is no set number of magnet clutch washers since they are used for adjusting.



d.
E271005

Using a snap ring expander, remove the snap ring.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.



e.

Detach the connector clamp and remove the magnet clutch rotor.


f.
E271006

Using a snap ring expander, remove the snap ring and magnet clutch stator.