Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050505 CENTER AIRBAG SENSOR ASSEMBLY G

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures of the airbag sensor assembly.


PROCEDURE

Hide 89170 1.INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

Hide 89170 2.INSPECT AIRBAG SENSOR ASSEMBLY (Vehicle Involved in Collision and Airbag not Deployed)


b.

Visually check for defects with the airbag sensor assembly installed on the vehicle.

i.

The defects are as follows:

·

Cracks on the sensor housing

·

Dents on the sensor housing

·

Chips on the sensor housing

·

Cracks or other damage to the connector

·

Peeling of the label


OK:

No defects are found.


HINT:

If any of the defects is found, replace the airbag sensor assembly with a new one.




Hide 89170 3.INSPECT AIRBAG SENSOR ASSEMBLY (Vehicle Involved in Collision and Airbag is Deployed)

a.

Replace the airbag sensor assembly.

HINT:

The airbag sensor assembly should be replaced after any of the airbags has deployed, as it has been subjected to an impact.