Home › Drivetrain › K111 MULTIDRIVE / CVT › DECELERATION SENSOR › 2012.12–2015.10
RM3090E _52 Drivetrain _008435 K111 MULTIDRIVE / CVT _0058108 DECELERATION SENSOR G

K111 MULTIDRIVE / CVT  DECELERATION SENSOR  INSPECTION  


PROCEDURE

Hide 89441A 1.CHECK DECELERATION SENSOR

a.

Check the deceleration sensor.

Under any of the following conditions, replace the sensor with a new one.

·

The surface of the sensor is cracked, dented, or chipped off.

·

The connector or wire harness is scratched, cracked, or damaged.

·

The sensor has been dropped.



Hide 89441A 2.INSPECT DECELERATION SENSOR

a.
C108887C01
2.115,0.938 1.49,0.75 1.49,0.75 1.49,0.969 false 2.281,0.927 2.323,0.417 2.323,0.417 2.042,0.417 false 2.531,0.958 2.646,0.531 2.646,0.531 2.771,0.531 false 1.24,0.323 1.917,0.552 0.677,0.229 10 2 (GGND) 2.813,0.469 3.344,0.75 0.531,0.281 10 3 (GL1) 1.26,1 1.833,1.177 0.573,0.177 10 1 (VGS) 2.448,2.438 2.667,2.646 0.219,0.208 10 *a 2.396,3.427 2.594,3.635 0.198,0.208 10 *b 1.052,4.208 1.25,4.406 0.198,0.198 10 *c
*a Front
*b Forward
*c Rearward


Connect 3 dry cell batteries of 1.5 V in series (approximately 4.5 V total).


b.

Connect the batteries' positive (+) lead to terminal 1 (VGS) and the negative (-) lead to terminal 2 (GGND).

NOTICE:

Do not apply 6 V or higher to terminals 1 (VGS) and 2 (GGND).



c.

Connect the voltmeter's positive (+) lead to the negative (-) lead of the batteries, and the negative (-) lead to terminal 3 (GL1).


d.

Check the output voltage of terminal 3 (GL1) when the sensor is tilted forward and rearward.

Standard voltage:
Tester Connection Sensor Position Specified Condition
3 (GL1) - Battery's negative (-) lead Horizontal Approx. 2.25 V
3 (GL1) - Battery's negative (-) lead Tilted forward Approx. 0.45 to 2.25 V
3 (GL1) - Battery's negative (-) lead Tilted rearward Approx. 2.25 to 4.05 V


If the result is not as specified, replace the deceleration sensor.

HINT:
·

If voltage drops, the sensor should be replaced with a new one.

·

When replacing the sensor, it should not be placed upside down.