| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Retainer plate x Generator drive end frame assembly | 2.3 | 23 | 20 | ||||
| Generator coil assembly x Generator drive end frame assembly | 5.9 | 60 | 52 | ||||
| Generator brush holder assembly x Generator coil assembly | 1.8 | 18 | 16 | ||||
| Generator rear end cover x Generator coil assembly | 4.6 | 47 | 41 | ||||
| Generator with clutch pulley x Generator coil assembly | with SST | 88 | 897 | 65 | |||
| without SST | 110.5 | 1127 | 81 | ||||
| Generator assembly x Cylinder block | 25 | 255 | 18 | ||||
| Wire harness x Terminal B | 9.8 | 100 | 87 | ||||
| Wire harness x Generator assembly | 7.7 | 79 | 68 | ||||
| Wire harness clamp bracket x Generator assembly
(for DPF) |
12.5 | 127 | 9 | ||||
| Negative (-) battery terminal x Battery | 5.4 | 55 | 48 | ||||
| Battery current sensor assembly x Negative (-) battery terminal | 7.6 | 77 | 67 | ||||
| No. 3 engine wire x Battery current sensor assembly | 7.6 | 77 | 67 | ||||